Raspberry Pi Foundation Launches $12 USB Debug Probe

The Raspberry Pi Foundation has a new gadget: a cheap, easy USB probe for debugging bare-metal code on a Pi Pico… but it should work with several other devices too.

The Debug Probe is a device to help debug bare-metal software on the Raspberry Pi Pico. The Pico is the Foundation's $4 single-board computer for microcontroller type roles. In embedded computers like this, there's often no display output, and in typical use, no operating system – both of which make it tricky to monitor what it's doing, or more to the point, work out why it's not doing it.

A common way to peer into the memory of an embedded Arm device and work out what it's doing is Arm's SWD interface, or Single Wire Debug – broadly, Arm's three-wire version of the traditional four- or five-wire JTAG interface.

However, to use those SWD signals, you need a device to read and translate them into something another computer can read and interpret, using software such as the FOSS OpenOCD or pyOCD. (In this context, OCD stands for On-Chip Debugger.) This device is called a debug probe.

Conveniently, a Raspberry Pi's GPIO interface can talk SWD over a few of its pins [PDF]. This means you can use one Pi to debug another Pi. That even includes the Pi Pico using some special firmware called Picoprobe. This is rather cheaper than a dedicated hardware debug probe. The snag is that you'll still need to wire up some circuits, as this blogpost describes.

Even if it's versatile – for instance, you can also use SWD to upload software into a Pi Pico from another Pi – it's not that easy, and if you want to use a bigger, faster computer, such as a PC or Mac, you then need to interface your Pi-based probe to that.

• The Balthazar laptop: An all-European RISC-V Free Hardware computer
• Don't expect a Raspberry Pi 5 in 2023, says Raspboss Eben Upton
• Raspberry Pi hires former spy gadget-maker who baked devices into surveillance ops
• This tiny Intel Xeon-toting PC board can take your Raspberry Pi any day

Which is the selling point of the new Pi Debug Probe. You plug one end into your Pi Pico, and the other end into a free USB port, and you're ready to go. It's a very low-end offering, but it should do the job – and it's $12. For comparison, a professional tool such as a Segger J-Link comes in at between $500 to $1000, and even an open-source hardware device such as an ORBtrace Mini – for instance from this store – is around ten times the price.

Better still, the Pi Debug Probe should be able to talk to any embedded device with an Arm Cortex M series and an SWD interface, such as the Arm-powered Arduino Due, or the 32-bit variants of the Teensy development boards. These are popular for tasks like equipping vintage keyboards with a USB interface. ®